Monday, 21 September 2015

Six men today, and lots of progress. Despite a very dreary start, and at one point the gang's refusal to leave the tea hut in the rain, we laid 41 slabs, with which we are well pleased. As we laid the final 3 slabs, the sun burst out and we left the scene on a high.

Heigh-ho, heigh-ho, it's off to work they go. John O and Keith march down the new platform...

...to find JC with a hired in mini digger lowering the infilled platform surface slightly, and more importantly, the line of slabs still to be laid, which was a bit too high (and very difficult to dig out by hand, with all the clay and roots)

Then a quickie left over from last week, laying a missing slab around a duct that came in at just the wrong height. Have you got a large diameter angle grinder handy, with a diamond cutting wheel?

Thought not.

We did today though, so the slabs were cut perfectly to size and this bit was signed off as finished. That's the southern half all slabbed up at the rear, and a good start made on the northern half.




Then, before we could carry on along the second half, we had to set out the next lengths of rear slabs to be laid.

We measure the distance from the platform edge, then the height using this long piece of 2x4, and a level. Adjust the string accordingly, and don't step on it. Yes, you there!




Is it going to stop anytime soon? Nah, mate...
An impromptu boot scraper, frequently in use



















While we do this, the rain continues to drizzle down. This has two effects: those who are doing hard work end up with giant clogs of clay round their boots, which is very irritating. Those that aren't doing much work huddle round the container with cups of tea and discuss what they would be doing, if it weren't raining quite so much.

Then, a glimmer of hope. After last week's dark picture of the Malverns, a beam of light lit them up today. The rain became episodic, then eased off, and work became quite pleasant.

For those not living in the UK, this is the valley of our second largest river, the Severn. Those Malvern hills represent the other side of the valley, then comes Wales.

We laid 20 lengths, then stopped to set out a further 20. You can see where this would take us - only two lamp posts to go if we finish there today. JC and Keith check the height of the new string.

The height of the string above ground level has to be checked carefully, otherwise the bed of lean mix and the edging slab won't fit. If the ground is too high, that's when the poking around in the gluey underground and the roots starts. Bob has a special gauge - a piece of ply, with a stripe on it. Works every time!

Once the ground is at the correct height, we can start slabbing again. Keith has just brought up another barrow full, while Bob is picking up an slab, which JC, who spent most of the day on his knees (no, not in front of the Finance Director!) is bedding down on the mix. That sign on the right seems to indicate 18 slabs to go, 111 laid. Nearly true ! We actually laid 41 slabs today, and have 31 to go out of the original 200 to be laid. One more good day should see us through.

During the idle hours in the rain, we calculated some statistics about the work we have done so far:

50.000 bricks laid
2000 concrete blocks laid
1200 barrows of mortar wheeled down the platform
240 Km of barrows pushed
90 tons of mortar made up
2 tons of cast iron planted

And only one work related accident. Paul pushed a barrow wrong. Yes, you might well ask yourself, how can you push a wheelbarrow in the wrong way? It's simple technology, no certificate required. We now know that it is possible, because Paul managed it!
In a fit of enthusiasm, he came rushing up with empty barrow and gusto, lifted the handles a tad too high, the front wheel guard dug into the ground, the barrow stopped dead, and Paul - sort of scrambled over the top of it. Ah. The injury in question was to his pride. Now healed, as he is still regaling us with his tales. Many tales. Many, many tales...

From the inner home signal, a view of CRC2 towards the end of the day, showing how far we got. 41 slabs laid in all today, just 31 to go. Nearly there. After that, the ramp to the level crossing remains to be done.

A last look of the day, at rural Gloucestershire. Sheep may safely graze. The sun has lit up a nearby hilltop. Imagine our surprise when a Chinook turned up one day, and deposited a group of soldiers on it!

As last week's historical picture clearly gave pleasure, here is another from the collection of Broadway photographer John Diston.

The picture was taken in 1959, and shows Jubilee class 45667 Jellicoe leaving Cheltenham Lansdown station with a Newcastle - Bristol train. This loco was scrapped in 1965 in Liverpool, its last shed.
The junction in the picture is where the rival Midland and GWR lines met, just south of the Cheltenham town centre. Our Honeybourne line is the one on the right. Malvern Road GWR station was just out of sight up our line, and is a builder's yard today. CRC is a couple of miles north of here.

As last week, any comments and additional information are very welcome. I have been allowed to borrow these pictures from John Diston's brother, and it would be nice if I could give them back with more details on them. Thanks for your help!

9 comments:

Anonymous said...

It makes you tired just reading the statistics, let alone achieving this target. Enormous effort. For your next cuppa during a rain break,- if the bricks, blocks and wheel barrows were placed end to end they would stretch from CRC to......
Mike Rose.

Anonymous said...

Fact: The river Severn is our longest river. It is over 6 miles longer than the Thames.
Regards,
Uncle Paul

Michael Johnson said...

The historic photo begs the obvious question: why was a junction station never built at Lansdown? It seems like a no-brainer, with two routes converging at that point.

But the Midland Railway and the Great Western couldn't agree terms, so the GWR built their own station at Malvern Road - not far away by train, but an awkwardly long walk by road.

To make the trek easier there was a footpath along the top of the cutting between Queens Road and Malvern Road station. It was a 'permissive' path rather than a public right of way, and it closed when Malvern Road station closed.

Looking at Queens Road bridge on Google Streetview, it seems the entrance to the path immediately to the east of the bridge has a new gate across it, as if it's a side gate to the adjacent house. Possibly the strip of land once occupied by the path now forms part of the garden.

Cheltenham town council recently put forward a proposal to build two new platforms at Lansdown station, on the Honeybourne line formation. This would have effectively created the junction station that the MR and GWR never built.

The idea was to create extra capacity for race days and terminating trains from South Wales, Paddington and Swindon. These trains currently wait in the sidings north of the station - now down to one track, which is a problem if trains are running late and don't arrive in the right order.

Unfortunately Network Rail didn't back the idea, but the council seem pretty certain it'll happen in the long term. After all, the capacity problems aren't going to go away.

The plan is here:

http://www.gloucestershire.gov.uk/CHttpHandler.ashx?id=55015&p=0

Michael Johnson said...

I wonder if anyone noticed one slightly odd feature of the historic pic - the signals on the gantry are all GWR lower quadrants, including the ones signalling the Midland line through Lansdown station.

That's because when the line between Cheltenham and Gloucester was quadrupled in 1941, the LMS did the track and the GWR did the signals.

Lansdown Junction signal box still exists, although it has been disused for many years. It was built to a wartime 'Air Raid Precautions' design, featuring very heavy brickwork and a concrete roof - intended to withstand bombs dropped nearby.

Jo said...

Thank you, Michael. I did notice that the gantry had unusual holes cut out of it - is that GWR practice?

Michael Johnson said...

The gantry does look curiously old fashioned. Other GWR gantries of the same period had a much lighter construction, with slim steel braces holding up the main beam. The support brackets on this one look like they could be cast iron plates.

I wonder if the gantry at Lansdown junction was made of second-hand parts. The work was done in wartime when resources were scarce, so the GWR may well have used older components which the S&T dept happened to have in store.

That's only my theory, but it's plausible!

stblazey1925 said...

Every time I look at a picture of CRC, I can't help but think that the new station building would look so much more authentic if a horizontal wooden batten the length of the end valancing just above the holes of the bottom, painted in dark stone could be fashioned; and would cost very little. Just a thought.

Peter said...

Hi
Do you need any more volunteers? I have just received my temporary work permit after being inspired by these blogs and needing to complete the necessary days I was wondering whether I could help
Many thanks
Pete

Jo said...

Hi Pete,
You are very welcome.
We kick off from 8am, I shall be there at 08.30.
Meet at the signal box, accessible through the race course, right at the northern end, follow the line of pine trees to the end.
Best regards,
Jo